Your cart is empty.
Go to catalog
Airlife K
Efficiently clean air in a kitchen ventilation system for a restaurant, cafe or bar. Remove smoke and unpleasant odors from the kitchen
add to cartThe Airlife K system is designed to effectively clean air in a kitchen ventilation system for a restaurant, cafe or bar. Recommended for installation in cooking areas where there is no open fire.
Airlife K completely removes smoke, soot, carbon particles and all odors from the air, i. e. all aerosol and gaseous pollution. After air passes through the Airlife KFK system, all indicators comply with legal requirements. The cleaning system reduce the concentration of contaminants below the level at which they can be detected by the human nose.
The Airlife K's high level of air purification makes it possible to:
- discharge kitchen air anywhere, including to the facade of a residential building at the ground level;
- open a restaurant in almost anywhere, including residential buildings and open spaces in shopping centers;
- keep the air in the dining area clean and fresh;
- save money on duct cleaning;
- install a heat exchanger to heat the restaurant using waste heat from the kitchen and to save on heating.
Installing a heat exchanger in a restaurant lets you use heat from kitchen stoves to heat rooms. But without pre-cleaning the air, the cells of a heat exchanger instantly become clogged with grease and oil. Airlife KFK completely removes all pollution from air, allowing the heat exchanger to supply a restaurant with heat from the kitchen from year to year, and the owner to significantly save on heating.
Airlife K air purification systems are reliable and easy to use on a daily basis. The management console lets you control the air purification system in real time.
All the equipment is guaranteed.
General characteristics
- Ambient operating temperature range:from -40 to +65 С
- Temperature range of cleaned air: from +5 to +78 С
- Supply voltage (50 Hz): 220/380V
- Environmental noise:0 dB
- Airflow volume:1000-16000 m³/hour
Additional characteristics
- Airflow resistance:200/300Pa
Cleaning efficiency
- Aerosols, smoke, soot and carbon particles:99.9%
- Organic pollutants, including unpleasant kitchen odors:99 %
Афимолл Сити
Чайхона №1
Кофе Хауз
ТРЦ «Европейский»
Сеть ресторанов «Шоколадница»
Сеть ресторанов Павлин-Мавлин
Кофейня Кофемания
Рестораны Шашлык-Машлык
Сеть ресторанов Теремок
Сеть ресторанов Бургер Кинг
Сеть ресторанов Грабли
Сеть ресторанов Кебаб-Хаус
Сеть ресторанов Сабвей
Control, automation and alarm unit
The control, automation and alarm unit keeps the air purifier operation under control.
Pre-filter
The pre-filter arrests large particles of dust and litter, poplar fluff, animal fur and soot clots. The pre-filter protects the other filtering elements against early contamination.
Aerosol charger
The unit structure creates a symmetrical electrostatic field inside the element and 99.8% efficiency of charging of the aerosol particles sized from 0.1 to 100 μm at the linear airflow velocity of 3 m/s. The unit consists of cylindrical stainless steel elements with a tungsten electrode with a diameter of 17 μm in the centre.
As high voltage is supplied to the electrodes, the charger develops an electric field that charges all contaminating particles in the airflow.
During the electrostatic unit operation, some ozone is generated to inactivate all types of microorganisms and to oxidize the chemicals arrested by the subsequent filters. The ozone is not released from the purification device as it gets oxidized in the photocatalytic unit.
Laminar precipitator
The filter is used for the precipitation of the charged oil particles of the size over 50 μm. The device is a unit of alternating charged plates made of stainless steel. As the voltage is relieved, the accumulated oil and grease drain into a special tray.
Photocatalytic filters
In the photocatalysis process, all gas air pollutants (unpleasant odours, toxic gases, allergens, viruses, bacteria etc.) are adsorbed on the photocatalyst surface and mineralized to simple, harmless components (carbon dioxide, water and atmospheric nitrogen) as they are exposed to soft UV-radiation (diapason A). Instead of accumulating on the filter, the pollutants are fully decomposed, so that the photocatalytic filter regenerates during operation.
The photocatalytic filter inactivates all types of microorganisms and oxidizes the toxic chemicals, including the ozone that is generated in the electrostatic unit.
Barrier electrostatic НЕРА filter
Barrier electrostatic HEPA filter arrests aerosols, smokes and dust particles sized over 0.1 μm that may carry unpleasant odours, toxic chemicals and hazardous microorganisms. The developed technology allows using the polarized dust HEPA filter as a charged particle precipitator to achieve the HEPA H14 purification class at the minimum airflow resistance and impressive dust and oil arresting capacity. The solid, liquid, and biological aerosol arrestance efficiency of the filter is 99%.
The main advantages of the AIRLIFE barrier HEPA filter are high capacity, low airflow resistance and affordability.
UV-A irradiation devices
Ultraviolet radiation activates the photocatalyst. In AIRLIFE air purifiers, the irradiation devices with the radiation diapason of 320-400 nm (UV-A diapason) are used; this is why the equipment can be used in the presence of people for an unlimited time. Due to the soft ultraviolet radiation, ozone is not generated.
Adsorption-catalytic filter
The adsorption-catalytic filter prevents the breakthrough of harmful substances during burst releases, as they are adsorbed on the surface of a catalytically active sorbent. The patented technology of a combination of the adsorption and photocatalytic filters keeps the sorbent catalytically active and regenerable in the operation process.
